High-lifter Daylight Kit for Yamaha Grizzly 660 Manuel d'utilisateur télécharger pdf

High Lifter Products, Inc. (318) 524-2270

780 Professional N. Dr. Fax (318) 524-2297

Shreveport, LA 71105

Yamaha Headlight & Mount

Installation Instructions

This light is simply spliced into the existing Yamaha headlight circuit behind either

headlight. When installed correctly the light will come on when the headlights are turned

on and will change from hi to low beam using the handlebar switch.

If you want to be able to turn this light off but leave the headlights on, simply install a

toggle switch in the ground circuit.

1. Install the light onto the bracket using the nut that is on the light.

2. Mount the light bracket to the handlebars using the 2 U-bolts and 4 Nylock nuts.

3. Using an ice pick or similar tool perforate the rubber plug in the Hella light

housing and thread the wires through the rubber plug. (Before stripping

insulation).

4. Install the Halogen bulb in the headlight being careful not to touch the bulb.

5. Install the black plastic connector inside the light housing.

6. Install the wires in the connector by pressing the clamps then inserting the wires

into the connector. (strip about ¼” of insulation)

7. Using test light, identify wires (ground, high beam, and low beam) to be spliced

(see attached diagram).

8. Disconnect ATV battery to prevent blown fuses.

9. Using the quick splice connectors attach the new wiring according to the diagram.

Verify continuity.

10. Trim excess wire; secure wire from hazards or potential abrasions. Reconnect

ATV battery.

Enjoy the new light and increased safety.

Packing List

12g White Wire-5’ 12g Red Wire-5’ 12g Black Wire-5’

10g-12g Quick Splice-3 Light Mount-1 Bulb-1

Connector-1 Light w/housing-1 U-blots 2ea

Nylock Nuts 4ea

1 2 3

High Lifter Products, Inc. (318) 524-2270 780 Professional N. Dr. Fax (318) 524-2297 Shreveport, LA 71105 Yamaha Headlight

Page 2

High Lifter Products, Inc. Yamaha Mount and Headlight Wiring Diagram

Page 3

Illustrations of Mounting Light to ATV 1. Mounting the light to the mounting bracket. 2. Mounting assembly to ATV handlebars.

Pas de commentaire

High-lifter Daylight Kit for Yamaha Grizzly 660 Manuel d'utilisateur