High-lifter Max Clearance Series Trailing Arm Kit for Polaris Manuel d'utilisateur télécharger pdf (Page 3)

Installation Instructions

1. Before you jack up the UTV make sure to disconnect the rear sway bar from the arms.

2. Once you have disconnected the sway bar from the arms remove any factory or aftermarket

rock guards. This may not apply to everyone just those UTV’s equipped with the rock guards.

3. Next, jack up the rear of the UTV, securing it properly so that it does not fall, but it allows the

arms to drop to full extension.

4. Unclip the brake lines from the arms. You can simply pull them out of the clips.

1 2 3 4 5 6 7 8 9

Pas de commentaire

High-lifter Max Clearance Series Trailing Arm Kit for Polaris Manuel d'utilisateur Page 3