High-lifter Max Clearance Front Lower Control Arms for Polaris Manuel d'utilisateur télécharger pdf (Page 4)

6. Now reinstall the bushings, sleeves, and ball joints into the new arms. If you

place some grease on them it makes the installations easier.

NOTE: A press or a vise is suggested for removing and replacing the ball

joints. If you press in the ball joint crooked, DO NOT TRY TO FORCE IT

IN! If you try to force it straight you can “egg” the opening. Press the ball

joint out and reinsert it into the opening, pressing it in with a vise. Verify

that the clip snaps into place after installing the ball joints into the new

Control Arm. You should always double check the ball joint snap ring for

proper fit. Even if you use snap ring pliers, it may not seat. You can use a

flathead screwdriver and a hammer to tap the snap ring to ensure that it is

seated into the grove.

1 2 3 4 5

Pas de commentaire

High-lifter Max Clearance Front Lower Control Arms for Polaris Manuel d'utilisateur Page 4